Scotsman SLE400R Manual de servicio Pagina 13

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 24
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 12
Initial Start Up
After the final check list has been gone through,
the ice machine may be started up.
1. Open the water shut off valve; the inlet water
valve will open, and water will flow into the
reservoir..
2. Switch on the electrical power.
3. Remove the front panel.
3. Locate the ICE/OFF/WASH switch,
switch it to WASH.
4. The water pump will begin to pump
water over the evaporators.
5. Allow the reservoir to refill. Normal water level is
1/8" below the high point of the lower curve of the
siphon u-tube.
6. Switch the ICE/OFF/WASH switch to OFF.
7. Check the action of the siphon. The water level
in the reservoir should drop to the bottom curve of
the U-bend (normal water level) in about 2
minutes. If not, check for proper drain tube
connections.
8. Remove right side panel.
9. Remove cap from “king” or service valve on the
receiver, and open the valve.
10. Switch the ICE/OFF/WASH switch to ON.
11. The remote fan motor will begin to turn, and
warm air will be discharged from the top of the
remote condenser.
12. The water temperature in the reservoir will
soon be 32
0
F., and ice should begin to form on the
evaporators.
13. Allow the ice machine to operate for about 20
minutes. The ice should be fully formed and
should be harvested within a few minutes.
14. After harvest, check the ice cube size.
Compare a fresh cube to the diagram on the
back of the front panel. If needed, adjust the
cube size by loosening the set screws and moving
the ice thickness probe adjustment plate.
Move the adjustment plate down for smaller
cubes and up down for larger.
For proper operation, the ice thickness should be
set to the 1
11
16
" diameter.
The machine is designed to harvest cubes of
only the correct thickness.
Cubes Too
Thick
Correct Size &
Shape
Cubes Too
Thin
1
11
16
"
Cube Size Diagram
Ice Size Adjustment
Set
Screws
Ice Thickness Probe
Adjustment Plate:
Move UP for Larger
Cubes,
DOWN for Smaller
Cubes
SLE400R
January 1995
Page 13
Vista de pagina 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comentarios a estos manuales

Sin comentarios