Scotsman NDE754 Manual de servicio descargar pdf (Pagina 21)

REMOVAL AND REPLACEMENT

WATER RESERVOIR

1. Shut off the water supply to the icemaker.

2. Remove front panel and reservoir cover.

3. To remove float only, pry the mounting flanges

apart enough to lift one float pivot pin out of the

flange hole, and pull float up and out of the

reservoir.

4. To remove reservoir, disconnect water inlet

compression fitting at reservoir inlet.

5. Remove drain hose from reservoir.

6. Remove evaporator inlet hose from reservoir.

7. Remove water level sensor probe.

8. Remove mounting screws from reservoir

bracket, and remove reservoir from icemaker.

9. Reverse to reassemble.

BIN CONTROLS (Ice Level Sensors)

1. Disconnect electrical power.

2. Remove front panel.

3. Remove control box cover.

4. Locate bin top, in front of and behind it are two

rubber bin control grommets.

5. Pull each bin control out, and in the control box,

disconnect the electrical leads connecting the bin

control to the circuit board.

6. Reverse to reassemble, be certain that the bin

controls are aligned so that the ice level sensors

are visible (centered) through the holes in the ice

chute.

NDE754

March 2000

Page 21

FLOAT

ASSEMBLY

LOCKING

TABS

Water

Sensor

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27

Sin comentarios

Scotsman NDE754 Manual de servicio Pagina 21