Scotsman FME1504 Manual de servicio descargar pdf (Pagina 5)

FOR THE PLUMBER

CONFORM TO ALL APPLICABLE CODES

Water Inlet

Air Cooled Models: Connect a water supply of

cold, potable water. Use 3/8" O.D. copper tubing

to connect to the 3/8" male flare at the back of the

cabinet. Install a hand valve near the machine to

control the water supply.

Water Cooled Models: Connect a separate 3/8"

O.D. copper line with a separate hand valve to the

3/8" FPT condenser inlet at the back of the cabinet.

The water pressure to all lines must always be

above 20 psig, and below 80 psig.

Drains

Air Cooled Models: Connect a drain tube to the

3/4" FPT drain fitting at the back of the cabinet. It

is a gravity drain, and 1/4 inch per foot fall is an

acceptable pitch for the drain tubing. There should

be a vent at the highest point of the drain line, and

the ideal drain receptacle would be a trapped and

vented floor drain.

Water Cooled Models: In addition to the above

mentioned drain, a separate condenser drain must

be installed. Connect it to the 1/2" condenser drain

connection at the back of the cabinet.

Storage Bin: A separate gravity type drain needs

to be run, similar to the air cooled drain.

Insulation of this drain line is recommended.

NME1254 & FME1504

January 2000

Page 5

Water Cooled

Connections

Hand Shut

Off Valve

Connect To

Cold Water

Filter, Field

Installed

(Optional)

Water Inlet

3/8" Flare

Bin Drain

3/4" FPT

Ice Machine

Drain

3/4" FPT

Use only 3/4" rigid tubing.

1 2 3 4 5 6 7 8 9 10 ... 28 29

NME1254 & FME1504 1

Comentarios a estos manuales

Sin comentarios

Scotsman FME1504 Manual de servicio Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas productoras de hielo Scotsman FME1504